FJRiders.com

Which one of these fit the FJR?

https://fortnine.ca/en/park-tool-oversi ... gLfm_D_BwE

OR

https://fortnine.ca/en/park-tool-headse ... gLwyPD_BwE


Canadian FJR

I'm not sure which.... might I suggest a 1/4" round bar of suitable length and you can tap them out.

raYzerman wrote: ↑Mon Nov 11, 2024 6:54 pm I'm not sure which.... might I suggest a 1/4" round bar of suitable length and you can tap them out.

+1
I used an old cluster shaft from a Muncie 4 speed. There's a blast from the past in vintage tools!

I’ve used pipes, rods, old screw drivers in the past. Just thought this would be a neat tool.


Canadian FJR

raYzerman wrote: ↑Mon Nov 11, 2024 6:54 pm I'm not sure which.... might I suggest a 1/4" round bar of suitable length and you can tap them out.

Canadian FJR wrote: ↑Mon Nov 11, 2024 7:48 pm I’ve used pipes, rods, old screw drivers in the past. Just thought this would be a neat tool.


Canadian FJR

Don't be getting between a man and his new tool Ray!

f@$k! You're right. He who dies with the most tools wins. And it will look Kool sitting in the tool box lookin' like new.

You guys are funny.