Page 1 of 1
MCL/Blackpath bar risers
Posted: Sat Jun 22, 2019 11:43 am
by CollingsBob
A small downside to fitting a RDL seat is a slightly greater lean to the bars. I’m considering bar risers...Do either the MCL or Blackpath risers necessitate extensions to the clutch or brake lines?
Re: MCL/Blackpath bar risers
Posted: Sat Jun 22, 2019 4:36 pm
by Bikenagain
MCL if you can find some don't need any extensions, just install and ride.
Re: MCL/Blackpath bar risers
Posted: Sat Jun 22, 2019 5:02 pm
by rbentnail
I used Genmar 1" for yrs & yrs, no mod of anything else required. I'm now using the old HeliBars replacement pullback top plate and the Genmar 1"- no modification of any hoses required other than re-routing on the right side. By "re-routing" no disconnection of any hoses or wiring, just push them to the inside towards the steering stem.
Re: MCL/Blackpath bar risers
Posted: Sat Jun 22, 2019 11:01 pm
by FJRoss
If I had known you were considering risers, you could have tried my Genmar risers out with your seat on my bike when I was there. No extensions needed if a 1" rise is enough for you.