Tech section strictly for the FJR. Everything from oil changes & suspension setup's to removing sheep hair from hard to reach places on the bike so that your wife never finds out.
268 Replies
493246 Views
Last post by bill lumberg
Sun Mar 09, 2025 6:26 pm
Where is the “Off Topic” area?
Replies: 19
by
extrememarine »
Fri Jan 18, 2013 9:47 pm
» in
Introductions
First post
Where is the “Off Topic” area?
Last post
Thank you - link updated!
19 Replies
104849 Views
Last post by extrememarine
Tue Aug 27, 2024 9:43 am
Exhaust Gasket Install
Replies: 25
by
HotRodZilla »
Thu Jul 14, 2022 12:09 pm
First post
Ok everyone, I need some ideas or help, or suggestions or what worked for you if you've had to replace one of these.
Last post
I have Leo Vince cans also. I keep saying, WTF are they talking about?
25 Replies
3738 Views
Last post by Powerman
Mon Jul 25, 2022 8:19 pm
FJR mirror extensions - 3D printing.
Replies: 1
by
Red »
Sun Jul 17, 2022 1:28 pm
First post
Riders,
Last post
Saving a click, here's a link to the actual file.
1 Replies
676 Views
Last post by DesignFlaw06
Sun Jul 17, 2022 4:03 pm
Bent rim - can it be straightened?
Replies: 14
by
senecahome »
Fri Jul 01, 2022 4:28 pm
First post
A bad pothole - slight ding on the edge of the rim (bead is still seated fine). Bike rides and tracks fine.
Last post
These folks do a great job...DAMHIK
14 Replies
2316 Views
Last post by El Toro Joe
Fri Jul 15, 2022 7:54 am
New Gen 3 Shock for a Gen 2 AE
Replies: 18
by
FJRPittsburgh »
Fri Jun 24, 2022 3:34 pm
First post
I recently purchased a Gen 3 rear shock and installed it on my 2008 Gen 2 AE this morning. I was thinking of upgrading to a Penske or Olins, but my...
Last post
You can control bouncing to a good degree, but it's a compromise when the spring rate isn't correct for you. Where have you got the rebound damping...
18 Replies
2895 Views
Last post by raYzerman
Thu Jul 07, 2022 5:52 pm
Gen 1 error code 21 troubleshooting
Replies: 2
by
PJ4863 »
Sun Jun 19, 2022 10:26 am
First post
Ug.. when it rains it pours. I finished re-wiring my rostra cruise control switch, went to go start the bike to trouble shoot any issues.. and error...
Last post
Glad you found it... if that was a Gen2 or 3, bike won't start with the coolant sensor connector not connected.
2 Replies
791 Views
Last post by raYzerman
Mon Jun 20, 2022 12:59 am
FJR Valve Adjustment
Replies: 39
by
fontanaman »
Sun Jun 05, 2022 4:07 pm
First post
Let's do something different. Rather than ask for help post mistake how about asking for help or tips as I go forward with adjusting the intake...
Last post
Valve adjustment successfully complete. All that remains is to wash it and take it for a shakedown ride. Wahoo!
39 Replies
9348 Views
Last post by fontanaman
Thu Jun 16, 2022 9:05 pm
*FIXED* fuel filler lock stuck/frozen
Replies: 6
by
wpbfjr »
Tue May 10, 2022 6:29 pm
First post
hi,
Last post
Awesome! One I hadn't heard of.
6 Replies
1201 Views
Last post by Panman
Tue May 10, 2022 9:07 pm
Rear fender flap - just curious
Replies: 3
by
senecahome »
Tue Mar 22, 2022 8:38 pm
First post
Does anyone know why Yamaha did not include the Flap on the front part of the rear fender in years 2013, 2014, 2015, It was included on Gen II and...
Last post
Made my own from black trash can remnants from Tenere accessories. :shock:
3 Replies
1025 Views
Last post by escapefjrtist
Tue Mar 22, 2022 10:22 pm
Side Stand Removal
Replies: 11
by
Canadian FJR »
Tue Mar 08, 2022 2:51 pm
First post
QUESTION: I tried to remove the side stand from my '03 to clean/paint it and I can't remove it. I removed the spring and the bolt but no go. It looks...
Last post
When in doubt, disconnect battery ground cable.
11 Replies
1693 Views
Last post by raYzerman
Wed Mar 09, 2022 11:32 am
Driveshaft Vent Cap
Replies: 9
by
Canadian FJR »
Thu Feb 10, 2022 4:46 pm
First post
Can this vent cap be removed (and reinstalled) without damaging anything.
Last post
Potty mouth 😂
9 Replies
1479 Views
Last post by Canadian FJR
Fri Feb 11, 2022 12:31 pm
AE Shift Error Codes 22 & 26
Replies: 29
by
yamafitter »
Thu Jun 17, 2021 5:59 pm
First post
I had my 2006 Antique FJR apart to service the rear suspension and had the swingarm out and a bunch of other stuff. After reassembly I had two error...
Last post
IF you go there, with the diagnostic connector to make software adjustments, might want to have a read..... error in FSM.
29 Replies
6735 Views
Last post by mcatrophy
Tue Feb 08, 2022 9:53 am
Rear aftermarket shock overhaul on a 2006 AE
Replies: 15
by
yamafitter »
Wed Mar 24, 2021 6:40 pm
First post
Many years ago I replaced the rear shock on my FJR AE with a Wilbers with remote reservoir and hydraulic preload adjuster. I had it serviced once by...
Last post
Many years ago I replaced the rear shock on my FJR AE with a Wilbers with remote reservoir and hydraulic preload adjuster. I had it serviced once by...
15 Replies
3048 Views
Last post by Road Runner
Wed Feb 02, 2022 8:53 am
Rotor Bolt Removal?
Replies: 9
by
dcarver »
Mon Jan 10, 2022 2:47 pm
First post
Sigh. KrZy8 needs new-to-me rotors installed.
Last post
“ heat the bolt and surrounding area with propane torch, get it nice and warm to loosen the loctite..
9 Replies
1655 Views
Last post by dcarver
Mon Jan 17, 2022 7:04 pm
Throttle Position Sensor Autopsy Gen3
Replies: 22
by
raYzerman »
Tue Dec 17, 2019 8:33 pm
First post
I posted this up on FJROwners as I had promised a member there, Slim Pickins (not THAT Slim Pickens) I would autopsy his TPS. He had replaced it on...
Last post
Hey my walker had flame decals curtesy of Tyler.
22 Replies
7437 Views
Last post by 0face
Thu Dec 16, 2021 6:29 pm
Bushtec Trailer Wheel Bearing Upgrade
Replies: 18
by
1911 »
Wed Dec 08, 2021 2:25 am
First post
I mentioned a couple near catastrophic wheel bearing failures on our Bushtec trailer in two different ride reports. Discussion about those bearings...
Last post
12mm wide is a 6203? A $6 bearing rated for 2250 pounds dynamic loads, 4 bearings per trailer. $6 each.
18 Replies
3085 Views
Last post by N4HHE
Thu Dec 09, 2021 3:18 pm
Brake rebuild
Replies: 5
by
Canadian FJR »
Sat Nov 20, 2021 1:19 pm
First post
I would have thought that you could pop the pistons out. First time I saw the blue cap removed.
Last post
Not replacing anything, just cleaned pistons and fresh fluid. I do this every winter.
5 Replies
2227 Views
Last post by FJRoss
Sat Nov 20, 2021 10:34 pm
Possible Failing Ignition Lock
Replies: 21
by
bill lumberg »
Mon Nov 15, 2021 11:20 am
First post
I’ve always kept my locks lightly lubed. Never an issue. Then, after a long day in the mountains, zero issues, the next morning, the bike is almost...
Last post
After irrigation, I blew it out with compressed air. No difference, but I did find that, if I rotate the key outward, in a clockwise fashion, almost...
21 Replies
3567 Views
Last post by bill lumberg
Wed Nov 17, 2021 4:56 am
Mileage after changing oil for winter storage
Replies: 21
by
CollingsBob »
Thu Oct 14, 2021 4:33 pm
First post
Ok…a bunch of you ‘muricans can just ignore this.
Last post
Don't know how much I agree with all of the Amsoil winterizing instructions. Advertizing to sell Amsoil stuff .
21 Replies
3389 Views
Last post by FJRoss
Wed Nov 10, 2021 9:38 pm
Inverted Forks on Gen 1
Replies: 2
by
Canadian FJR »
Wed Nov 03, 2021 7:44 pm
First post
Could one install a new Gen front end on a Gen 1 by simply replacing the steering head, inverted forks and wheel?
Last post
Qualified maybe, but for GEN I would be a difficult swap. Not straightforward and likely not worth the cost and aggravation. First, whole front...
2 Replies
946 Views
Last post by escapefjrtist
Wed Nov 03, 2021 10:03 pm
Bend R-Gaza Saddlebag Bars?
Replies: 4
by
Ludwig61 »
Sat Oct 30, 2021 6:24 pm
First post
Hello!
Last post
I had ordered another set from Amazon before I posted this, in case I couldn't find workable bending advice. Rather than flex it towards weakness for...
4 Replies
1046 Views
Last post by Ludwig61
Mon Nov 01, 2021 7:09 pm
Oil change kit
Replies: 4
by
Boston »
Sun Oct 24, 2021 10:49 am
First post
I do not know if anybody talked about this before. (didn't bother to look)
Last post
If the kit isn't model-specific, it is possible that the other crush washers are for different bikes. AFIK, the fill hole and drain for the final...
4 Replies
1144 Views
Last post by Boston
Fri Oct 29, 2021 9:03 am
Tech Day in North Georgia
Replies: 26
by
Toter »
Fri Oct 15, 2021 7:34 pm
First post
Hey guys. Talked to Andy at EOM, thinking about doing a tech day at my place here in North Georgia. I am not a tech guru. Would need them to come and...
Last post
Not sure if Jwilly or Lumberg have tire machines.
26 Replies
4045 Views
Last post by BikerGeek
Fri Oct 22, 2021 4:10 pm
Aftermarket wave rotors
Replies: 41
by
dcarver »
Sun Jun 27, 2021 7:01 pm
First post
KrZy8, 247k miles, stock rotors.. hard to believe, but they are under minimal width.
Last post
Too bad EBC doesn't make rotors for the Audi RS3. To save weight, they thinned the rotors to a minimum. You can't turn them even once.
41 Replies
7714 Views
Last post by Bounce
Tue Oct 19, 2021 10:58 am
Where is the paint code?
Replies: 2
by
2WheelJon »
Sun Sep 12, 2021 8:00 pm
First post
Got to do a little touch up on my 2007 FJR. Where do I find the paint code?
Last post
Found Colorite and ordered the paint from them.
2 Replies
1519 Views
Last post by 2WheelJon
Mon Sep 13, 2021 7:50 pm
Power tap location
Replies: 8
by
fencer »
Sat Sep 11, 2021 3:18 pm
First post
What is the suggested location and wire code to tap into for a key switchable on relay for electronic add ons?
Last post
Admore Lighting plug and play harness here. No taps, no splices.
8 Replies
2321 Views
Last post by rbentnail
Sun Sep 12, 2021 9:16 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forum
