New to the bike and just finished flushing the radiator. Following instructions from FJR Tech, when I ran the bike to temp the fan would only kick on...
Last post
Another thread dicked up by bar hopping sheep mongers.
I've had those VERY nice Aerostitch helmet lock/bar ends ( ) on my 04 since the day I bought it. I use them all the time. So I thought I'd move them...
When I change my rear tire I put the center stand on a 2x4 so the rear wheel and tire clears the rear fender. This works well until installing wheel...
Last post
You want the changer to be at a height so that when you have the bar set to change the tire, the end of the bar rests on your hip. I find this gives...
That plate that goes across the bottom that holds the adjuster for the shock that has been gone for years, and the Voltage regulator I think? Is the...
Last post
I should've at least honked. Sorry...
I thought about stopping, but the kids were jacked up on Mt. Dew.
You would not want that in close...
Don managed to snap off the windscreen of his POS GenIII while it was still on the trailer being towed to Owosso. We are not sure if it was the bike...
Last post
f@$k riding across Kansas, they can give that piece of shit state back to the Indians and we Americans have not lost a god damn thing! jes' sayin'...
Sorry if this has been done to death-I'm posting here hoping not to get flamed.
Riding the FJR, I get the feeling that there's a beast under too much...
Last post
If you go hunting on the other forum, Uselesspickles spend a good amount of time with his '08 on the dyno. The primary focus was developing the...
I have been a full sportbike rider for a lot of years (R1/R6 for many of them) but, as I am no longer as young as I used to be, I'm...
Last post
Thanks for the thoughts, I was leaning the same way. I think I would like the throttle-by-wire and cruise, but wonder would all the electronics be a...
a few weeks ago i bout an '08 with the clutch. ran beautiful on test rides and i didn't figure 10k miles was a lot for a 5 year old bike. figured out...
Last post
I saw the original Skynyrd 9th row from the front. Great show, they were f'd up. Never saw so many JD bottles on the floor of the Saint Paul, Mn....
other than the clutch issue my new to me '08 seems pretty squared away so i took out for a couple of tankfuls on sunday. in 20+ years of motorcycles...
Last post
the day longs look comfy as all get out, but it looks like moving around during corners may be restricted. how is the russell if one moves around in...
I am working on a power distribution module for my '13. I want to place the module under the seat and need to run a 10 gage positive wire...
Last post
If you have a superior Gen II, you can run the wires under the tank above the foil insulation pad and not worry about heat. A loom or protective tape...
What are the chances someone would actually need a fjr frame? I've sat on this one from the totaled bike since october, not one hint of there being a...
Last post
definitely makes you stop and rethink it, doesn't it. I'm with clocklaw Ok, so this made me instantly concerned that I gave you some bad advice. :o...
Since I am new to the FJR I figured it might be best to inquire about this here. Anyway today I noticed a slight but distinct higher frequency whine...
Last post
My ex was diagnosed as bi-polar after we divorced.
I just installed the PCV I bought from FuelMoto. It was easy to install and worked perfectly. It fixed the snatchy crap throttle on my 07 FJR. It did...
Last post
I just installed the PCV I bought from FuelMoto. It was easy to install and worked perfectly. It fixed the snatchy crap throttle on my 07 FJR. It did...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum